Is there a way to re-map a range of program changes?
I’ve found the Program Re-map MIDI filter but it only seems to allow one at a time?
I need to remap incoming PC 1-64 to 65-128. It seems a bit inelegant to have to use 64 separate MIDI filters.
How about a simple route filter? I put this into an embedded rack:
Now any program change < 64 (zero-based) sent to this rack will be transposed by 64.
You can do this directly in your relevant route as well; just wanted to illustrate this in a kind of “utility rack”.
Give it a whirl and check if it works!
Cheers,
Torsten
2 Likes
Thank you sir.
It’s obvious once you point it out!
For some reason yesterday I couldn’t figure this out.
Had another go and still can’t figure it out.
What I’m trying to do is select songs from the setlist by PC from my Fantom.
I have 2 bands on the go and all the scenes for Band A are in the Fantom in slots 1-64. It sends out a PC corresponding to the slot number which I have intercepted by a background rack selecting the appropriate song.
Of course, when I load the setlist for Band B and use the slots 65-128 in the Fantom I can only get it to work by numbering the songs in the setlist 65-128 but that triggers my OCD having the set start at song 65.
It’s not a major issue but would be nice to figure out.