Flush tail sounds on suspend

It looks like I don’t understand the “Flush tail sounds on suspend” setting. I’ve got several reverb and delay plugins in an embedded rack for my guitar FX, and when suspending them (via a MIDI foot controller) the tail sounds are immediately cut off.

I’d like the tail sounds to continue after turn the plugin off (i.e. the remainder of the delay to sound). I don’t really mind how I do that - bypass / suspend / mute the input to the plugin / whatever - as long as I can bind it to a MIDI message. Here’s roughly how my FX song (I just have 1) is set up:

I’ve done a little bit of digging in this forum and can’t find the answer, but I assume the problem is with me rather than Cantabile! Thanks!

Hi Chris,

To do what you want you don’t use the flush tails but instead leave the plugin or rack enabled and use the MIDI input route to the plug or rack as the way you stop new notes from being sent. To do this rename the input routes to a name you like and use the bindings to set up a switch for the route. In this example I have renamed the input route to “Route” and it it sent to the rack named Route.

and here is the binding to enable/disable the route

The only rule is that you have to have your hands up when you switch so any note offs will have already been sent. I hope this helps. :slight_smile:

Dave

Thanks for the response, but I’m talking about an audio signal - not MIDI notes. Sorry if I wasn’t clear!

I’ll give what you suggest a try, I assume it will work for audio signals as well. Thank you :+1:

Oh! My bad, sorry. In this case I looked at your construction of your routing and it appears to be wired in series. That being the case you can’t really achieve the preservation of the reverb tails using that wiring method. I would look at creating parallel routing for the dry and effected signals. Like this example

You would have to rename the audio input routes so you could disable only the dry signal and leave the reverb alone and still enabled for the tails to play out.

Does this make sense?

That makes perfect sense, thank you. My FX were in parallel (the image I posted wasn’t clear) so the only thing I needed to do is figure out how to name the routes - F2 did the trick and it now works beautifully! Thank you so much :+1:

1 Like

Glad it worked and sorry for the confusion! :smiley:

1 Like

Hey there,
Just to top and tail Dave’s comprehensive solution, ‘Flush Tails’ is a function that you may well find yourself requiring at some point. Flush Tails will, for the most part (it’s not 100%) kill the residue from a plugin once it’s been bypassed. This is to avoid anything which may be still sitting in a buffer from kicking back in when the plugin is reactivated.

1 Like