FCB1010 Volume Pedal

I have had the FCB1010 for some time and it has been a godsend, but it is a pain to programme. I have invested in a 2nd hand UNO chip which has made the two volume pedals workable. I have set one to control overall Cantabile volume, but the leaves any internal sounds on my MX61 unaffected. How do I get the second volume pedal to send CC7 messages to my MX61? (PS I cannot use the UNO software as I do not have the licence number for the chip s it was second hand).

I’ve been using the free FCB 1010 Editor by Ed Dixon for years, which makes it incredibly easy to program everything. Unfortunately I can’t seem to find an active download link for you. I don’t use the UNO chip but it will definitely program that as well.

You might also try searching deeper for ā€œFCB1010 Editor Mountain Systemsā€. Note that if you get it, IIRC you need to run it in Compatibility Mode, I think I used Win 7 effectively. If you can’t find it anywhere then PM me, I can probably dig up the original Setup file, I must have it somewhere.

There’s an alternative product by Mountain Utilities that I could never get to work properly. But maybe you can.

I have 3 of these pedals and I love them since I haven’t had any issue with them for around 7-8 years of gigging with them. FWIW I use it with a CME Widi Master going to Bluetooth on my Win 10 machines… love it, just plug in power on the pedal and play.
Tom

found it, this is the ā€œlatestā€ version, here you go…

Tom

Here’s the link for the Mountain Utilities one:

but it does say;

"

  • Support for FCB1010 firmware versions 2.4 and 2.5.
  • No support for Ossandust’s ā€˜UnO’ firmware.

"

1 Like