i’m using TouchOSC but i suspect this issue would be apparent with other midi controllers.
i’m using an x/y pad with y being the gain of an output slider.
in order to make the gain ‘playable musically’ i have set the binding to to be -32db to +6db with quite a curve (i wish the curves displayed a number rather than just be a slider) with the curve slider being set about the middle of the triangle of the ‘out of range’ drop down.
that works nicely when i play on the TouchOSC device.
now i’d like to reflect changes from C3 changes back to TouchOSC.
i make the reverse binding and set the range to be identical.
i move the gain slider in C3 and it is not at all the same when displayed in TouchOSC.
i then tweak about to improve matters.
i retain the -32 and +6db but i move the curve slider to the opposite side and it reflects much better the gain slider but is still a bit jumpy in TouchOSC
has anyone any ideas what i’m doing wrong?