Binding differents parameter with one midi input

[arsy]

Hi everyone

Sorry if the subject were already discussed, but I haven’t found it.

I have an issue.

I want to bind differents parameters with only one midi input, let say a slider from my keyboard. But only the first binding is working and the other are not moving.

Is there a solution ?

[dave_dore]

It would help if you post a screen shot of the bindings list you made.

[cdv_gabriel]

I second @dave_dore: a screenshot could help. Anyway, I suspect that you have not set the first binding to “Continue” mode, so that the others don’t see the event.

Activate binding group with a binding

Hi Thom, Bindings have 3 different Routing Modes. If you have a series of Bindings triggered with the same Source event, you can set the first one to “Suppress” and it will not continue to the next Binding; the following Bindings will be suppressed. Conversely, you can set a Binding to “Continue” and the following Binding (with the same Source) will be triggered. Bindings will be triggered until one is set as “Suppress” or there are no more Bindings with the same source. To access the Binding …

Gabriel

[arsy]

I checked and both are set to continue

[cdv_gabriel]

Hi @arsy,

I have tried the same setup (but with a different plugin, OB-XD, controlling the detune and xmod with CC17). It works, at least on my system. I am on Cantabile 4196.

Which version of Cantabile are you using? The binding system has been changed at some point (after 4100).

New Bindings System Available Now (build 4100)

It’s finally here! I’ve just put up Cantabile build 4100 which includes the new bindings implementation. I started work on this almost a year ago thinking it would take a couple of weeks - turns out it was a much bigger job than anticipated (and there were some distractions along the way). In any case a first experimental build is now available! So what’s changed? New UI The biggest difference you’ll notice is the UI has changed. Rather than bindings being edited in a single slot, with var…

Gabriel

P.S: you could also try adding a delay to the second binding, in case the plugin needs some time the process the first one.

[brad]

Make sure the first binding has have routing mode “continue”, not “suppress”: